Zte ZXV10 W615 - Page 54

ZXV10 W615 User Manual
52 Confidential and Proprietary Information of ZTE CORPORATION
2. Configure the parameters. Refer to the following table.
Parameter Description
Enable Enables or disables the MAC filter function. This
function is disabled by default.
Mode Select a filtering mode: Discard or Permit.
Type Specifies the type: Bridge, Route, or
Bridge+Route.
Protocol Specifies the protocol: IP, Address Resolution
Protocol (ARP), Reverse Address Resolution
Protocol (RARP), PPPoE, or ALL.
Source MAC Address MAC address of the device on the LAN side.
Destination MAC Address MAC address of the device on the WAN side.
Modify
Click to modify the corresponding MAC
filter rule.
Delete
Click to delete the corresponding MAC filter
rule.