IES4005M User’s Guide 139
CHAPTER 17
Static Multicast Commands
Use these commands to configure static multicast settings.
17.1 Static Multicast Commands Summary
Use static multicast to allow incoming frames based on the VLAN ID and multicast MAC addresses
that you specify.
The following table describes commonly used parameter notation for these commands.
This table describes the commands.
Table 92 Static multicast command parameters
Notation Description
uni-vlan The VLAN ID on the UNI (User Network Interface) ports, 1-4093.
mac This is a static multicast MAC address (01:00:5e:00:00:00 ~ 01:00:5e:7f:ff:ff) which
identifies the multicast group.
Table 93 Static multicast commands summary
Command Description M P
interface dsl <slot/portlist> Enters the sub-command mode for configuring the specified DSL
ports.
C13
smcast <mac> uni-vlan <uni-vid> Configures a static multicast group and the VLAN ID that incoming
frames from the multicast group must be tagged with.
Note: Make sure the VLAN is configured in VLANTrunk or VLAN
Translation mode before using this command.
C13
smcast <mac> uni-untag Configures a static multicast group with no VLAN tagged. That is,
the ports only accept untagged frames from the multicast group.
C13
no smcast <mac> Removes the specified static multicast group. C 13
show interface dsl <slot/portlist>
smcast
Displays static multicast settings on the specified DSL ports. E 13
To Next Page
Loading...
