ZyXEL Communications IES4005M - Hardware Monitor Commands

Chapter 11 Management
IES4005M User’s Guide
88
11.3 Hardware Monitor Commands
Use these commands to view hardware monitor statistics and set hardware monitoring alarm limits.
You can set maximum and minimum allowed speeds for individual fans, maximum and minimum
allowed temperatures and voltages for individual sensors in the management card and line cards.
This table describes the commands.
time daylight-saving-time startdate
<week> <day> <month> <o-clock>
Sets the day and time when Daylight Saving Time starts.
In most parts of the United States, Daylight Saving Time
starts on the second Sunday of March at 2 A.M. local time.
In the European Union, Daylight Saving Time starts on the
last Sunday of March at 1 A.M. GMT or UTC, so the o’clock
field depends on your time zone.
C13
time daylight-saving-time end-date
<week> <day> <month> <o-clock>
Sets the day and time when Daylight Saving Time ends. In
most parts of the United States, Daylight Saving Time
ends on the first Sunday of November at 2 A.M. local time.
In the European Union, Daylight Saving Time ends on the
last Sunday of October at 1 A.M. GMT or UTC, so the
o’clock field depends on your time zone.
C13
show time server
Displays the time server settings. E 1
time server
Has the system synchronize its time with the time server
every 24 hours.
C13
no time server
Disables synchronizing the system time with the time
server.
C13
time server type <daytime|time|ntp>
Sets the time server type.
daytime: Daytime Protocol (RFC 867)
time: Time Protocol (RFC 868)
ntp: SNTP (RFC 2030)
C13
time server address <ip-
address>|<ipv6-address>
Sets the IP address of the time server in IPv4 or IPv6
format.
ip-address: 0.0.0.0 ~ 223.255.255.255
ipv6-address: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
C13
time server sync
Synchronize the current system time with time server. C 13
Table 60 Date and Time Commands Summary (continued)
COMMAND DESCRIPTION M P
Table 61 Hardware Monitor Commands Summary
COMMAND DESCRIPTION M P
show hw-monitor
Displays the system monitor settings. E 1
show hw-monitor statistics [slot
<slot>]
Displays the system monitor statistics summary.
slot: 1-5, 1 is the control card. 2-5 are the line cards.
E1