ZyXEL Communications IES4005M - PPPoE Intermediate Agent Commands Summary

Chapter 21 PPPoE Intermediate Agent
IES4005M User’s Guide
152
21.1 PPPoE Intermediate Agent Commands Summary
The following table describes commonly used parameter notation for these commands.
This table describes the commands.
Table 104 PPPoE Intermediate Agent Command Parameters
NOTATION DESCRIPTION
info
The PPPoE intermediate Agent circuit ID and remote ID. It can use the following
components:
special characters except % => ~`!@#$^&*()-=_+{}<>?,./
%%: equals character %
%0x00-%0xFF: represents byte value
%pname: configured port name
%pid: port index
%chvpi: channel VPI
%chvci: channel VCI
%slotid: slot index of the logic port
%svlan: SVLAN ID which PPPoE client runs on
%cvlan: CVLAN ID which PPPoE client runs on
%hname: host device name
%cmac1: MAC address of a PPPoE client, in XX:XX:XX:XX:XX:XX format where X=0-F
%cmac2: MAC address of a PPPoE client in XXXXXXXXXXXX format where X=0-F
%cmac3: MAC address of a PPPoE client in Bytes
%dmac1: MAC address of the host device in XX:XX:XX:XX:XX:XX format where X=0-F
%dmac2: MAC address of the host device in XXXXXXXXXXXX format where X=0-F
%dmac3: MAC address of host device in Bytes
%phtype: ATM: atm Ethernet eth
%hmodel: model name of the host device
%fwid: host device firmware ID
%blank: blank character
Table 105 PPPoE Intermediate Commands Summary
COMMAND DESCRIPTION M P
pppoe transparent vlan <vid>
Enables PPPoE packet transparent on the specified VLAN. PPPoE
transparent and intermediate agent can not be enabled at the same
time in a VLAN.
C13
no pppoe transparent vlan
<vid>
Disables PPPoE packet transparent on the specified VLAN. C 13
pppoe intermediate-agent vlan
<vid>
Enables PPPoE intermediate agent on the specified VLAN. PPPoE
transparent and intermediate agent can not be enabled at the same
time in a VLAN.
C13