ZyXEL Communications IES4005M - VLAN TLS Commands

Chapter 25 VLAN
IES4005M User’s Guide
186
The following table describes commonly used parameter notation for these commands.
This table describes the commands.
25.3.1 Command Examples
This example enables port 4 of the line card in slot 2 and also enables VLAN transparent and loop
guard on it.
25.4 VLAN TLS Commands
Use these commands to configure Transparent LAN Service (TLS) on the IES. Transparent LAN
Service (also known as VLAN stacking or Q-in-Q) allows a service provider to distinguish multiple
customers VLANs, even those with the same (customer-assigned) VLAN ID, within its network.
Use TLS to add an outer VLAN tag to the inner IEEE 802.1Q tagged frames that enter the network.
By tagging the tagged frames (“double-tagged” frames), the service provider can manage up to
4,093 VLAN groups with each group containing up to 4,093 customer VLANs. This allows a service
provider to provide different services, based on specific VLANs, for many different customers.
A service provider’s customers may require a range of VLANs to handle multiple applications. A
service provider’s customers can assign their own inner VLAN tags to traffic. The service provider
Table 126 Transparent VLAN Command Parameters
NOTATION DESCRIPTION
vpi
The VPI (Virtual Path Indicator) 0-255.
vci
The VCI (Virtual Channel Indicator) 32-65535.
Table 127 Transparent VLAN Commands Summary
COMMAND DESCRIPTION M P
interface dsl <slot/portlist>
Enters the sub-command mode for configuring the specified DSL ports. C 13
exit
Leaves the DSL port configuration. C 13
vlan transparent
Enables transparent VLAN on the specified DSL ports. In PTM mode, a
DSL port is a logical Ethernet port.
C13
no vlan transparent
Disables transparent VLAN on the specified DSL ports. C 13
vlan transparent atm-vc
<vpi>/<vci>
Enables transparent VLAN on the specified DSL ATM virtual circuit. In
ATM mode, an ATM PVC is a logical Ethernet port.
C13
no vlan transparent atm-
vc <vpi>/<vci>
Disables transparent VLAN on the specified DSL ATM virtual circuit. C 13
ras# config
ras(config)# interface dsl 2/4
ras(config-interface-dsl-2/4)# active
ras(config-interface-dsl-2/4)# vlan transparent
ras(config-interface-dsl-2/4)# loopguard
ras(config-interface-dsl-2/4)# exit
ras(config)# exit
ras#