IES4005M User’s Guide 205
CHAPTER 27
IEEE 802.1x Authentication
Use these commands to configure IEEE 802.1x authentication for authenticating subscribers.
IEEE 802.1x is an extended authentication protocol that allows support of RADIUS (Remote
Authentication Dial In User Service, RFC 2138, 2139) for centralized user profile management on a
network RADIUS server.
27.1 802.1x Command Summary
The following table describes commonly used parameter notation for these commands.
Table 136 dot1x command parameters
Notation Description
info The option 82 circuit ID format. It can use the following components:
special characters except % => ~`!@#$^&*()-=_+{}<>?,./
%%: equals character %
%0x00-%0xFF: represents byte value
%pname: configured port name
%pid: port index
%chvpi: channel VPI
%chvci: channel VCI
%slotid: slot index of the logic port
%svlan: SVLAN ID which a DHCP client runs on
%cvlan: CVLAN ID which a DHCP client runs on
%hname: host device name
%cmac1: MAC address of a DHCP client in XX:XX:XX:XX:XX:XX format where X=0-F
%cmac2: MAC address of a DHCP client in XXXXXXXXXXXX format where X=0-F
%cmac3: MAC address of a DHCP client in Bytes
%dmac1: MAC address of the host device in XX:XX:XX:XX:XX:XX format where X=0-F
%dmac2: MAC address of the host device in XXXXXXXXXXXX format where X=0-F
%dmac3: MAC address of the host device in Bytes
%phtype: ATM: atm, Ethernet: eth
%hmodel: model name of the host device
%fwid: host device firmware ID
%blank: blank character
To Next Page
Loading...
