ZyXEL Communications IES4005M - Command Modes; Modes for Privilege Levels 0-12; Modes for Privilege Levels 13-14

Chapter 9 The CLI
IES4005M User’s Guide
75
In the following example, the login user account has a privilege level of 0 but knows that the
password for privilege level 13 is pswd13. Afterwards, the session’s privilege level is 13, instead of
0, and the session changes to enable mode.
9.6.3.4 disable Command
This command reduces the session’s privilege level to 0. It also changes the session to user mode.
This command is available in enable mode. In the following example, user tom changes his session
privilege to 14 and then changes the privilege again to 0.
9.7 Command Modes
The CLI is divided into modes. Certain commands are available in certain command modes. The
modes that are available depend on the session’s privilege level.
9.7.1 Modes for Privilege Levels 0-12
If the session’s privilege level is 0-12, the user and all of the commands are in user mode. Users do
not have to change modes to run any allowed commands.
9.7.2 Modes for Privilege Levels 13-14
If the session’s privilege level is 13-14, the allowed commands are in one of these modes.
ras# enable 13
Password: pswd13
ras#
User name: tom
Password: ******
ras# enable 14
Password:
ras# disable
ras>
Table 55 Command Modes for Privilege Levels 13-14
MODE PROMPT DESCRIPTION
enable
ras#
Displays current configuration, diagnostics,
maintenance.
configuration
ras(config)#
Configures features other than those below.