ZyXEL Communications IES4005M - Line Card Management; Line Card Management Commands Summary

IES4005M User’s Guide 107
CHAPTER 12
Line Card Management
Use these commands to enable, disable, reset, or display status information about line cards.
12.1 Line Card Management Commands Summary
This table describes the commands.
12.1.1 Command Examples
This example shows how to check all card states and activate a card before you can use it:
1 Display all line cards’ status. The result shows three cards are installed (the MSC1002G, one ADSL
card, and one VoIP card.
2 Activate (provision) slot 2 where the ADSL card is installed.
Note: You can only use a slot after you provision it. Here “use” means to use interface
related commands such as interface, show interface, clear interface
commands. After you provision the slot for a type of line card, you can only use
that type of line card in the slot. Provisioning a slot with a wrong provision type
cannot activate the slot.
Table 74 Line Card Management Commands Summary
COMMAND DESCRIPTION M P
lcman slot <slot> provision-
type <card type>
Configures the line card type of the specified slot. You must do this to
be able to use a line card in the slot. You can only use a slot after you
provision it. After you provision the slot for a type of line card, you can
only use that type of line card in the slot.
slot: slot number 2 ~ 5
card type: card type alc (ADSL2+), vlc (VDSL2), or vop (VoIP)
C13
lcman disable <slot>
Disables the line card in the specified slot. E 13
lcman enable <slot>
Enables the line card in the specified slot. E 13
lcman reset slot <slot>
Resets the line card in the specified slot. E 13
show lcman
Displays the status of the installed line cards. Optionally, displays the
information of specified installed line card.
E13