ZyXEL Communications IES4005M - Command Examples; SNMP Server Commands

Chapter 11 Management
IES4005M User’s Guide
91
11.4.1 Command Examples
This example shows the current configuration of port 1 on slot 2. Then it shows how to copy the
port’s configuration to port 7 on slot 2. Finally, this example also shows the configuration of port 7.
11.5 SNMP Server Commands
Use these commands to configure SNMP on the IES.
SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network switches. SNMP is a member of TCP/IP protocol suite. A manager station can
manage and monitor the system through the network via SNMP version one (SNMPv1) and/or
SNMP version 2c. The next figure illustrates an SNMP management operation. SNMP is only
available if TCP/IP is configured.
ras# show running-config interface dsl 2/1
Building configuration...
Current configuration:
#SLOT 2 ALC1132G-51
interface dsl 2/1
active
loopguard
loopguard uni-vlan 100
vlan transparent
exit
ras# copy running-config interface dsl 2/1 2/7
ras# show running-config interface dsl 2/7
Building configuration...
Current configuration:
#SLOT 2 ALC1132G-51
interface dsl 2/7
active
loopguard
loopguard uni-vlan 100
vlan transparent
exit
ras#