ZyXEL Communications IES4005M - Running Configuration Commands

Chapter 11 Management
IES4005M User’s Guide
89
11.4 Running Configuration Commands
Use these commands to back up and restore configuration and firmware.
This table describes the commands.
hw-monitor fan-speed-threshold
<index> <high> <low>
Sets the high and low fan speed limits for raising an alarm on the
specified fan.
index: 1-3
high: 0-15000 in RPM
low: 0-15000 in RPM
C13
hw-monitor temperature-threshold
<slot> <index> <high> <low>
Sets the high and low temperature limits for raising an alarm on
the specified module and sensor.
slot: 1-5, 1 is the control card. 2-5 are the line cards.
index: 1-10
high: -50-100 in degree Celsius
low: -50-100 in degree Celsius
C13
hw-monitor voltage-threshold
<slot> <index> <high> <low>
Sets the high and low voltage limits for raising an alarm on the
specified module and sensor.
slot: 1-5, 1 is the control card. 2-5 are the line cards.
index: 1-3
high: 0-25000 in mV
low: 0-25000 in mV
C13
Table 61 Hardware Monitor Commands Summary (continued)
COMMAND DESCRIPTION M P
Table 62 Running Configuration Commands Summary
COMMAND DESCRIPTION M P
copy running-config interface
dsl <slot>/<port> <slot/
portlist> [<attribute>
[<...>]]
Clones (copies) the attributes from the specified DSL port to other DSL
ports. Optionally, copies the specified attributes from one port to other
ports.
E13
copy running-config interface
ge-nni <port> <portlist>
[<attribute> [<...>]]
Clones (copies) the attributes from the specified GE NNI port to other
GE NNI ports. You can specify a single port <1>, all ports <*> or a list
of ports <1,2>. You can also include a range of ports <1-2>.
E13
copy running-config interface
voip <slot>/<port> <slot/
portlist> [<attribute>
[<...>]]
Clones (copies) the attributes from the specified VoIP port to other
VoIP ports. Optionally, copies the specified attributes from one port to
other ports.
E13
erase running-config
Resets the IES to the factory default settings. E 13
erase running-config
interface dsl <slot/portlist>
[<attribute> [<...>]]
Resets the specified DSL ports to the factory default settings on a per-
port basis and optionally on a per-feature configuration basis.
E13