ZyXEL Communications IES4005M - Initial Setup; Changing the Administrator Password; Changing the Management IP Address

IES4005M User’s Guide 79
CHAPTER 10
Initial Setup
This chapter identifies tasks you might want to do when you first configure the IES.
10.1 Changing the Administrator Password
Note: It is recommended you change the default administrator password.
Use this command to change the administrator password.
admin-password <password> <confirm-password>
where <password> and <confirm-password> may be 1-32 alphanumeric characters long.
10.2 Changing the Enable Password
Note: It is recommended you change the default enable password.
Use this command to change the enable password.
password <password>
where <password> may be 1-32 alphanumeric characters long.
10.3 Changing the Management IP Address
This command changes the management IP address for remote access.
ip inband address <ip-address>/<mask>
or this command changes the management IP address for local access.
ip outband address <ip-address>/<mask>
ras# configure
ras(config)# admin-password t1g2y7i9 t1g2y7i9
ras# configure
ras(config)# password k8s8s3dl0