ZyXEL Communications IES4005M - Page 196

Chapter 26 VoIP
IES4005M User’s Guide
196
voip diagnostic mlt test
<slot>/<port>
<all|vac|vdc|rload|riso|cap|r
en|ring|metering|dialtone|dig
it|roh> [force]
Performs metallic line test on the specified VOIP ports
all: Perform all tests on the line connected to the specified VoIP line
card port.
vac: Test the line’s AC voltage only.
vdc: Test the line’s DC voltage only.
rload: Test the line’s load resistance only
riso: Test the line’s isolation resistance only.
cap: Test the line’s capacitance only.
ren: Test the line’s ringer equivalent number only.
ring: Test the line’s ring voltage only.
metering: Test the line’s metering voltage only.
dialtone: Test the line’s dialtone only.
digit: Test if the line circuit accepts dialed digits and switches the call
to its destination.
roh: Test if the receiver is off hook only.
force: Perform the test(s) immediately, even if the port is in use.
E13
show voip h248
Displays H.248 configuration. E 13
voip h248
Enters the sub-command mode for configuring the global H.248
settings.
C13
exit
Leaves the global H.248 settings configuration sub-command mode. C 13
clear statistics
Clears control packet statistics. C 13
digit-map-timeout <start-
timeout> <short-timeout>
<long-timeout>
Configures digit collection timeout
start-timeout: Set the timeout period if the user doesn't send any
DTMF signal after off-hook, in seconds (0-99). 0 disables the timeout.
short-timeout: Set the H.248 short time-out, in seconds (1-99). You
define the short and long timeout values and the IES selects which to
use.
long-timeout: Set the H.248 long time-out, in seconds (1-99). You
define the short and long timeout values and the MGC selects which to
use.
default:
start-timeout: 16
short-timeout: 4
long-timeout: 4
C13
dscp <dscp>
Configures the value of the DSCP bit (0-63) carried on H.248 packets.
Default:48
C13
encode long|short
Configures the text encoding type of the H.248 messages the IES
sends out.
long: long text encoding
short: short text encoding
default: long text
C13
Table 135 VoIP Commands Summary (continued)
COMMAND DESCRIPTION M P