Chapter 6 Connection Status
Nebula Mobile Router User’s Guide
100
Each field is described in the following table.
6.1.6 WiFi Settings
Use this screen to enable or disable the main wireless network. When the switch turns blue ( ), the
function is enabled. You can use this screen or the QR code on the upper right corner to check the SSIDs
(WiFi network name) and passwords of the main wireless networks. If you want to show or hide your WiFi
passwords, click the Eye icon ( ).
Figure 52 WiFi Settings
Table 22 Cloud Control Status
LABEL DESCRIPTION
Nebula Discovery Enable this to have the Zyxel Device connect to the NCC and change to the NCC
management mode if the Zyxel Device is connected to the Internet and has been
registered on the NCC. This is not configurable and will only display ON when your Zyxel
Device is being managed by NCC.
Cloud Control
Status
This field displays:
• The Zyxel Device Internet connection status.
• The connection status between the Zyxel Device and the NCC.
• The Zyxel Device registration status on the NCC.
Mouse over the circles to display detailed information.
To pass your Zyxel Device management to the NCC, make sure your Zyxel Device is
connected to the Internet. Then go to the NCC and register your Zyxel Device.
Internet
• Green: The Zyxel Device is connected to the Internet.
• Orange: The Zyxel Device is not connected to the Internet.
Nebula
• Green: The Zyxel Device is connected to the NCC.
• Gray: The Zyxel Device is not connected to the NCC.
Registration
• Green: The Zyxel Device is registered on the NCC.
• Gray: The Zyxel Device is not registered on the NCC.
Please note that all circles will gray out if you disable Nebula Discovery. When a circle is gray
or orange, hover the mouse over the circle to check the diagnostic message.
QR Code Click on the QR code icon at the top right corner to show the QR code you can use to
register the Zyxel Device on the NCC using the Nebula Mobile app.
To Next Page
Loading...
