Chapter 8 Wireless
Nebula Mobile Router User’s Guide
150
8.9 Channel Status
Use this screen to scan for WiFi channel noise and view the results. Click Scan to start, and then view the
results in the Channel Scan Result section. The value on each channel number indicates the number of
Access Points (AP) using that channel. The Auto-channel-selection algorithm does not always directly
follow the AP count; other factors about the channels are also considered. Click Network Setting >
Wireless > Channel Status. The screen appears as shown.
Note: If the current channel is a DFS channel, the warning ‘Channel scan process is denied
because current channel is a DFS channel (Channel: 52 – 140). If you want to run
channel scan, please select a non-DFS channel and try again.’ appears.
Note: The AP count may not be a real-time value.
Figure 90 Network Setting > Wireless > Channel Status
The following table describes the labels in this screen.
Table 55 Network Setting > Wireless > Channel Status
LABEL DESCRIPTION
Channel Monitor
Wireless Network Setup
To Next Page
Loading...
