ZyXEL Communications Nebula LTE3301-PLUS - Changing Security on a Wifi Network

Chapter 5 Web Interface Tutorials
Nebula Mobile Router User’s Guide
57
Figure 40 WiFi Network Setup
Figure 41 Zyxel Device Configuration through WiFi Connection
See the label on the Zyxel Device for the WiFi network settings and then connect manually to the Zyxel
Device. Alternatively, you can set up a WiFi network using WPS. See Section 5.3.2 on page 59.
5.3.1 Changing Security on a WiFi Network
This example changes the default security settings of a WiFi network to the following:
1 Go to the Network Setting > Wireless > General screen. Select More Secure as the security level and
WPA3-SAE/WPA2-PSK as the security mode. Configure the screen using the provided parameters. Click
Apply.
SSID Example
Security Mode WPA3-SAE/WPA2-PSK
Pre-Shared Key DoNotStealMyWiFi
802.11 Mode 802.11b/g/n Mixed