Chapter 2 Hardware Panels
Nebula Mobile Router User’s Guide
33
2.3.3 Nebula NR5101
Figure 14 Nebula NR5101
The following table describes the ports and buttons on your Nebula NR5101.
2.3.4 Nebula NR7101
Figure 15 Nebula NR7101
Table 11 Nebula NR5101 Panel Ports and Buttons
LABELS DESCRIPTION
ANT1-ANT2 / Antenna Install the external antennas to strengthen the cellular signal.
Note: To use the external antennas, you must set the INT/EXT switch to EXT.
USB The USB port of the Zyxel Device is used for file sharing.
LAN2/WAN LAN mode: Connect a computer to the LAN using an RJ45 cable.
WAN mode: Connect the Zyxel Device to the Internet through the WAN.
LAN1 Connect a computer to the LAN using an RJ45 cable.
WiFi Press for 1 second: Enable or disable WiFi.
Press for more than 5 seconds: Activate WPS connection process.
RESET Press for 2 seconds: Reboot the Zyxel Device.
Press for 5 seconds: Restore the Zyxel Device to its factory default settings.
POWER Button Press the POWER button after the power adapter is connected to start the Zyxel Device.
POWER Connect the power adapter and press the POWER button to start the Zyxel Device.
Micro SIM Insert a micro-SIM card into the slot with the chip facing down and the beveled corner
in the top left corner.
INT/EXT Select between the internal or external cellular antennas.
To Next Page
Loading...
