Chapter 37 Troubleshooting
Nebula Mobile Router User’s Guide
309
4 If the problem continues, contact the vendor.
The LED does not behave as expected.
1 Make sure you understand the normal behavior of the LED.
2 Check the hardware connections.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Turn the Zyxel Device off and on.
5 If the problem continues, contact the vendor.
37.3 Device Access Problems
I do not know the IP address of the Zyxel Device.
1 The default IP address is 192.168.1.1.
2 If you changed the IP address, you might be able to find the IP address of the Zyxel Device by looking
up the IP address of your computer’s default gateway. To do this in Microsoft Windows, click Start > Run,
enter cmd, and then enter ipconfig. The IP address of the Default Gateway might be the IP address of
the Zyxel Device, depending on your network environment.
3 If this does not work, reset the Zyxel Device to its factory defaults.
I forgot the admin password.
1 See the Zyxel Device label or this document’s cover page for the default admin password.
2 If you changed the password from default and cannot remember the new one, you have to reset the
Zyxel Device to its factory default settings.
I cannot access the Web Configurator login screen.
1 Make sure you are using the correct IP address.
• The default IP address is 192.168.1.1.
To Next Page
Loading...
