Chapter 7 Broadband
Nebula Mobile Router User’s Guide
126
7.10 Cellular IP Passthrough
Enable IP Passthrough to allow Internet traffic to go to a LAN computer behind the Zyxel Device without
going through NAT.
Click Network Setting > Broadband > Cellular IP Passthrough to display the following screen.
Note: This screen is not available when the fourth LAN port acts as an Ethernet WAN port.
Note: This screen is not available for models that support the IP Passthrough settings in the
Network Setting > Broadband > Cellular APN > Edit screen.
Note: This screen is not available if Ethernet WAN is enabled at
Network Setting > Broadband >
Ethernet WAN > State
.
Figure 73 Network Setting > Broadband > Cellular IP Passthrough
Note: Changing the IP Passthrough settings may affect the network setting of client devices.
After selecting to enable the following warning appears. Click OK to continue.
Figure 74 Network Setting > Broadband > Cellular IP Passthrough > Enable Warning
To Next Page
Loading...
