ZyXEL Communications Nebula LTE3301-PLUS - MGMT Services for IP Passthrough

Chapter 29 Remote Management
Nebula Mobile Router User’s Guide
280
Figure 183 Maintenance > Remote Management > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
29.5 MGMT Services for IP Passthrough
Configure which interfaces you can use to access the Zyxel Device in IP Passthrough mode for a given
service. You can also specify the service port numbers computers must use to connect to the Zyxel
Device. IP Passthrough allows Internet traffic to go to a LAN computer behind the Zyxel Device without
going through NAT. Make sure to enable IP Passthrough in Network Setting > Broadband > Cellular IP
Passthrough.
Click Maintenance > Remote Management > MGMT Services for IP Passthrough to open the following
screen.
Figure 184 Maintenance > Remote Management > MGMT Services for IP Passthrough
Table 122 Maintenance > Remote Management > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IP Address Enter a public IPv4/IPv6 IP address which is allowed to access the service on the
Zyxel Device from the WAN.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to restore your previously saved settings.