Chapter 7 Broadband
Nebula Mobile Router User’s Guide
129
Figure 76 Network Setting > Broadband > Cellular Lock (5G)
The following table describes the fields in this screen.
7.12 Cellular SMS
Use this screen to send and receive SMS messages using the SIM card installed in the Zyxel Device.
Click Network Setting > Broadband > Cellular SMS. The following screen displays.
Table 39 Network Setting > Broadband > Cellular Lock (5G)
LABEL DESCRIPTION
NR(5G) Lock Management
PCI_Enable Click the switch button (to the right) to enable PCI (Physical Cell Identifier) Lock on a
base station when the Zyxel Device has a 5G NR connection.
Band Enter the band number to which you choose to connect.
Note: Make sure to select the same band in the Network Setting > Broadband
> Cellular Band screen so as the Zyxel Device can connect to that
band.
PCI Use this to enter the PCI number of the base station you want the Zyxel Device to
connect to (0 – 504).
RFCN Enter the RFCN (Radio Frequency Channel Number) for the 5G NR frequency of the
specified PCI (1 – 65535).
SCS Select the Subcarrier Spacing (SCS) from the drop-down list. Subcarriers are small signal
carriers that divide a frequency channel, which is the main carrier wave. Subcarrier
spacing is the space between each subcarrier. At the time of writing, SCS ranges from
15-120 KHz.You should select the same SCS that is used by the ISP.
Cancel Click this to exit this screen without saving.
Apply Click this to save your changes.
To Next Page
Loading...
