Chapter 8 Wireless
Nebula Mobile Router User’s Guide
143
Note: The WPS switch is unavailable if the wireless LAN is disabled.
If WPS is enabled, UPnP will automatically be turned on.
Click Network Setting > Wireless > WPS. The following screen displays. Click this switch and it will turn blue.
Click Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 85 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 50 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Click to enable ( ) and have the Zyxel Device activate WPS. Otherwise, it is disabled.
Add a new device with WPS Method
Method 1 PBC Use this section to set up a WPS WiFi network using Push Button Configuration (PBC). Click this
switch to make it turn blue. Click Apply to activate WPS method 1 on the Zyxel Device.
WPS Click this button to add another WPS-enabled WiFi device (within WiFi range of the Zyxel
Device) to your WiFi network. This button may either be a physical button on the outside of a
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other WiFi device’s WPS button within 2 minutes of pressing
this button.
Method 2 PIN Use this section to set up a WPS WiFi network by entering the PIN of the client into the Zyxel
Device. Click this switch to make it turn blue. Click Apply to activate WPS method 2 on the Zyxel
Device.
To Next Page
Loading...
