Chapter 19 Parental Control
Nebula Mobile Router User’s Guide
242
Add New Service
Use this screen to add a new service rule.
Figure 159 Security > Parental Control > Add or Edit PCP > Add New Service
The following table describes the fields in this screen.
Modify Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule.
Site/URL Keyword
Block or Allow
the Web Site
If you select Block the Web URLs, the Zyxel Device prohibits the users from viewing the Web sites
with the URLs listed below.
If you select Allow the Web URLs, the Zyxel Device blocks access to all URLs except ones listed
below.
Add Click Add to show a screen to enter the URL of web site or URL keyword to which the Zyxel
Device blocks or allows access.
# This shows the index number of the rule.
Website This shows the URL of web site or URL keyword to which the Zyxel Device blocks or allows access.
Modify Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule.
Cancel Click Cancel to exit this screen without saving any changes.
OK Click OK to save your changes.
Table 100 Security > Parental Control > Add or Edit PCP > Add New Service
LABEL DESCRIPTION
Add New
Service
Select the name of the service from the drop-down list. Otherwise, select User Define and specify
the name, protocol, and port of the service.
If you have chosen a pre-defined service in the Service Name field, this field will not be
configurable.
Protocol Select the transport layer protocol used for the service. Choices are TCP, UDP, or TCP & UDP.
Port Enter the port of the service.
If you have chosen a pre-defined service in the Service Name field, this field will not be
configurable.
Table 99 Security > Parental Control >Add or Edit PCP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
