Chapter 29 Remote Management
Nebula Mobile Router User’s Guide
278
Figure 181 Maintenance > Remote Management > MGMT Services
The following table describes the fields in this screen.
Table 120 Maintenance > Remote Management > MGMT Services
LABEL DESCRIPTION
Service Control
WAN Interface
used for services
Select Any_WAN to have the Zyxel Device automatically activate the remote management
service when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the Zyxel Device
activate the remote management service when the selected WAN connections are up.
Cellular WAN Enable the cellular WAN connection configured in Network Setting > Broadband > Cellular WAN
to access the service on the Zyxel Device.
If there are multiple cellular WANs configured on the Zyxel Device, you can select which to use
for device management.
ETHWAN Enable the Ethernet WAN connection configured in Network Setting > Broadband > Ethernet
WAN to access the service on the Zyxel Device.
Service This is the service you may use to access the Zyxel Device.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the LAN or WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from all WAN connections.
Trust Domain Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the trusted host IP address.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the Zyxel Device.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
