Chapter 8 Wireless LAN Profiles
NWA/WAC Series CLI Reference Guide
53
dcs client-aware {enable|disable} When enabled, this ensures that the NWA/WAC will not change
channels as long as a client is connected to it. If disabled, the
NWA/WAC may change channels regardless of whether it has
clients connected to it or not.
dcs channel-deployment {3-channel|4-
channel}
Sets either a 3-channel deployment or a 4-channel deployment.
In a 3-channel deployment, the AP running the scan alternates
between the following channels: 1, 6, and 11.
In a 4-channel deployment, the AP running the scan alternates
between the following channels: 1, 4, 7, and 11 (FCC) or 1, 5, 9,
and 13 (ETSI).
Set the option that is applicable to your region. (Channel
deployment may be regulated differently between countries and
locales.)
dcs 2g-selected-channel wlan_channel_2g Sets a 2.4 GHz channel to use (1~14).
dcs dcs-5g-method {auto} Sets how you specify the channels the NWA/WAC switches
between for 5 GHz operation.
dcs dfs-aware {enable|disable} Enable this to allow an NWA/WAC to avoid phase DFS channels
below the 5 GHz spectrum.
[no] dot11n-disable-coexistence Fixes the channel bandwidth as 40 MHz. The no command has the
NWA/WAC automatically choose 40 MHz if all the clients support
it or 20 MHz if some clients only support 20 MHz.
[no] frag <256..2346> Sets or removes the fragmentation value for this profile.
The threshold (number of bytes) for the fragmentation boundary
for directed messages. It is the maximum data fragment size that
can be sent.
The default is 2346.
guard-interval wlan_htgi Sets the guard interval for this profile.
The default for this is short.
[no] htprotect Activates HT protection for this profile. Use the no parameter to
disable it.
By default, this is disabled.
limit-ampdu < 100..65535> Sets the maximum frame size to be aggregated.
By default this is 50000.
subframe-ampdu <2..64> Sets the maximum number of frames to be aggregated each
time.
By default this is 32.
limit-amsdu <2290..4096> Sets the maximum frame size to be aggregated.
The default is 4096.
[no] multicast-to-unicast “Multicast to unicast” broadcasts wireless multicast traffic to all
wireless clients as unicast traffic to provide more reliable
transmission. The data rate changes dynamically based on the
application’s bandwidth requirements. Although unicast provides
more reliable transmission of the multicast traffic, it also
produces duplicate packets.
The no command turns multicast to unicast off to send wireless
multicast traffic at the rate you specify with the 2g-multicast-
speed or 5g-multicast-speed command.
Table 22 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
