ZyXEL Communications nwa series - Page 54

Chapter 8 Wireless LAN Profiles
NWA/WAC Series CLI Reference Guide
54
role {ap} Sets the profile’s wireless LAN radio operating mode.
Use ap to have the radio function as an access point with one or
more BSSIDs.
rssi-dbm <-20~-76> When using the RSSI threshold, set a minimum client signal
strength for connecting to the AP. -20 dBm is the strongest signal
you can require and -76 is the weakest.
rssi-kickout <-20~-90> Sets a minimum kick-off signal strength. When a wireless client’s
signal strength is lower than the specified threshold, the NWA/
WAC disconnects the wireless client.
-20 dBm is the strongest signal you can require and -90 is the
weakest.
[no] rssi-retry Allows a wireless client to try to associate with the NWA/WAC
again after it is disconnected due to weak signal strength.
Use the no parameter to disallow it.
rssi-retrycount <1~100> Sets the maximum number of times a wireless client can attempt
to re-connect to the NWA/WAC.
[no] rssi-thres Sets whether or not to use the Received Signal Strength
Indication (RSSI) threshold to ensure wireless clients receive
good throughput. This allows only wireless clients with a strong
signal to connect to the NWA/WAC.
tx-mask chain_mask Sets the outgoing chain mask.
rx-mask chain_mask Sets the incoming chain mask.
exit Exits configuration mode for this profile.
show wlan-monitor-profile {all | rule_count |
[monitor_profile_name]}
Displays all monitor profiles or just the specified one.
rule_count: Displays how many monitor profiles are created on
the NWA/WAC.
wlan-monitor-profile rename
monitor_profile_name1 monitor_profile_name2
Gives an existing monitor profile (monitor_profile_name1) a
new name (monitor_profile_name2).
[no] wlan-monitor-profile monitor_profile_name Enters configuration mode for the specified monitor profile. Use
the no parameter to remove the specified profile.
[no] activate Makes this profile active or inactive.
By default, this is enabled.
description description Sets the description for the profile. You may use up to 60
alphanumeric characters, underscores (_), or dashes (-). This
value is case-sensitive
scan-method scan_method Sets the channel scanning method for this profile.
[no] 2g-scan-channel wireless_channel_2g Sets the broadcast band for this profile in the 2.4 Ghz frequency
range. Use the no parameter to disable it.
[no] 5g-scan-channel wireless_channel_5g Sets the broadcast band for this profile in the 5 GHz frequency
range. Use the no parameter to disable it.
scan-dwell <100..1000>
Sets the duration in milliseconds that the device using this profile
scans each channel.
exit Exits configuration mode for this profile.
Table 22 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION