Chapter 6 Multy M1 (WSM20) Modes
Multy WiFi System User’s Guide
146
Figure 50 Settings > System > Status (Standard Mode)
The following table describes the labels shown on the Status screen.
Table 12 Settings > System > Status (Standard Mode)
LABEL DESCRIPTION
System
Model Name This is the model name of your device.
Firmware Version This is the firmware version.
System Operation Mode This is the device mode to which the Multy Device is set, see Section 7.11 on page 167
for more information.
Enable IPv4 Firewall This shows if the IPv4 firewall is enabled on the Multy Device.
Enable IPv6 Simple
Security
This shows if the IPv6 firewall is enabled on the Multy Device.
System Uptime This is the total time the Multy Device has been on.
WAN Information
MAC Address This shows the WAN Ethernet adapter MAC address of your device.
IP Address This shows the WAN port’s IP address.
To Next Page
Loading...
Need help?
General
