EasyManuals Logo

ZyXEL Communications SCR 50AXE User Manual

ZyXEL Communications SCR 50AXE
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Chapter 1 Get to Know Your Multy WiFi System
Multy WiFi System User’s Guide
16
Figure 7 Standard Mode Example
Auto-IP Change
When the Multy Device (A) gets a WAN IP address or a DNS server IP address which is in the same subnet
as the LAN IP address 192.168.123.1, Auto-IP Change allows the Multy Device to change its LAN IP
address to 10.0.0.1 automatically. If the Multy Device’s original LAN IP address is 10.0.0.1 and the WAN IP
address is in the same subnet, such as 10.0.0.3, the Multy Device switches to use 192.168.123.1 as its LAN
IP address.
Figure 8 Auto-IP Change Example
Auto-IP Change only works under the following conditions:
The Multy Device must be in standard (router) mode for Auto-IP Change to become active.
The Multy Device is set to receive a dynamic WAN IP address.
1.4.2 Bridge Mode
Use your Multy Device as a bridge if you already have a router or gateway on your network. In this mode
your Multy Device bridges a wired network (LAN) and WiFi in the same subnet. In bridge mode, Multy
Device has one IP address and Multy Device interfaces are bridged together in the same network. In
the example scenario below, Multy Device connects the local network to the Internet through a router
(R).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZyXEL Communications SCR 50AXE and is the answer not in the manual?

ZyXEL Communications SCR 50AXE Specifications

General IconGeneral
BrandZyXEL Communications
ModelSCR 50AXE
CategoryNetwork Router
LanguageEnglish

Related product manuals