Chapter 2 Hardware
Multy WiFi System User’s Guide
30
Figure 28 WSQ65 Desk Placement
2.3 WPS Button
Use the WPS button to quickly set up a secure WiFi connection between the Multy Device and a WPS-
compatible client device by adding one device at a time. See Table 2 on page 9 for more information.
To activate WPS:
1 Make sure the LED lights turns steady blue and not blinking.
2 Press the WPS button until the LED light blink pink and release it.
3 Press the WPS button on another WPS-enabled client device within range of the Multy Device within 120
seconds. The LED blinks pink while the Multy Device sets up a WPS connection with the other WiFi client
device.
4 Once the connection is successfully made, the LED turns steady green.
2.4 Reset Button
If you need to return the Multy Device to its default settings, use the reset button on the rear panel.
To Next Page
Loading...
Need help?
General
