Chapter 7 Web Interface Tutorials – Multy M1 (WSM20)
Multy WiFi System User’s Guide
160
3 After you click Apply, the Multy Device Web Configurator will go to the Parental Control > Device >
Device Detail screen. Make sure the parental control profile you created has been applied to the
specific client.
Disable a Parental Control Profile
You can disable the parental control profiles to stop the Multy Device from blocking the connected
clients during the time you set.
Suppose you no longer need to block a specific client from accessing the Internet during the time for
studying. Go to Parental Control > Profile and find the Study profile. Slide the switch to the left ( ) to
disable the profile.
7.7 Configure a Firewall Rule
This section shows you how to enable the firewall to protect your network from malicious attacks from
the Internet.
7.7.1 Enable Respond to Ping and Firewall
Enable Respond to Ping to activate Internet Control Message Protocol (ICMP) on the Multy Device.
Enable Firewall to protect the Multy Device from DoS attacks.
ICMP
Internet Control Message Protocol (ICMP) is a message control and error-reporting protocol between a
host server and a gateway to the Internet. Enable this to have the Multy Device respond only to
incoming Ping requests from the specified interface. Attackers can ping the devices to find their
locations through their responds then attack them. If you set the Multy Device to not respond to Ping
requests from the WAN, the attackers will not be able to find the Multy Device since they can’t receive
responds from it. This will prevent the Multy Device from been attacked.
To Next Page
Loading...
Need help?
General
