Chapter 7 Web Interface Tutorials – Multy M1 (WSM20)
Multy WiFi System User’s Guide
162
2 Click Add Rule and enter the service name, destination IP address and MAC address as given above.
3 Click Apply to save your changes.
Block Packets from a Specified IP Address
The example below shows you how to block an advertisement website from sending packets to all
clients connected to the Multy Device. The following example uses the parameters below to configure
the access control rule.
1 Set Rule Status to Enable and Actions to Drop.
2 Click Add Rule and enter the service name and source IP address as given above.
Table 18 Access Control Rule Example Parameters
SERVICE NAME SOURCE IP ADDRESS ACTIONS
Ads Website 1.1.1.1 Drop
To Next Page
Loading...
