Chapter 8 Web Interface Tutorials – Multy Plus (WSQ60)
Multy WiFi System User’s Guide
193
• Standard: This is the Multy Device’s default mode. In this mode, the Multy Device routes traffic
between a local network and another network such as the Internet. If you wish your Multy Device to
have Access Control, UPnP, Port Forwarding, DMZ function, choose this mode.
• Bridge: Use this mode so the Multy Device bridges traffic between clients on the same network. You
can choose this mode if you have an existing router.
Note: AiShield, Access Control, UPnP, Port Forwarding, DMZ are not available in Bridge mode.
1 Click the Navigation Panel icon on the top-left corner ( ). From the Settings drop-down list, click
Maintenance, then click the Operating Mode tab. Select the operating mode and select APPLY to save
your changes. Changing the Multy Device’s operating mode may take up to 2 minutes.
To Next Page
Loading...
