Chapter 11 Network Address Translation (NAT)
VMG1312-B Series User’s Guide
188
11.2.1 Add/Edit Port Forwarding
Click Add new ru le in t he Port Forw arding screen or click the Edit icon next to an exist ing rule to
open t he following screen.
Figure 74 Port Forwarding: Add/ Edit
The following t able describes t he labels in t his screen.
Protocol This shows the I P prot ocol support ed by this virtual server, whether it is TCP, UDP, or TCP/
UDP.
Modify Click the Edit icon t o edit t his rule.
Click the D e let e icon to delete an exist ing rule.
Table 51 Network Sett ing > NAT > Port Forwarding ( cont inued)
LABEL DESCRIPTION
Table 52 Port Forwarding: Add/ Edit
LABEL DESCRIPTION
Act ive Clear t he checkbox to disable t he rule. Select t he check box t o enable it.
Service Nam e Ent er a nam e t o identify this rule using keyboard charact ers ( A- Z, a- z, 1- 2 and so on).
WAN I nterface Select the WAN int erface through which t he serv ice is forwar ded.
You m ust have already configured a WAN connect ion with NAT enabled.
WAN I P Enter the WAN I P address for which the incom ing service is dest ined. I f the packet ’s
dest ination I P address doesn’t m at ch t he one specified here, t he port forwarding rule will
not be applied.
St art Port Ent er t he original destinat ion port for the packets.
To forward only one port, ent er the port num ber again in t he End Por t field.
To forward a series of ports, enter the start por t num ber here and t he end port num ber in
the End Port field.
To Next Page
Loading...
