Chapter 1 Introduction
WAH7003 User’s Guide
11
Figure 1 WAH7003 OLED Display
The following table describes the OLED icons.
1.7 Resetting the WAH7003
If you forget your password or IP address, or you cannot access the Web Configurator, you will need
to use the physical Reset button to reload the factory-default configuration file. This means that
you will lose all configurations that you had previously saved, the password will be reset to admin
and the IP address will be reset to 192.168.0.254.
1.7.1 How to Use the Physical Reset Button
1 Make sure the WAH7003 is turned on.
Table 1 WAH7003 OLED Icons
ICONS DESCRIPTION
The more bars that display, the stronger the signal strength.
The type of the mobile network to which the WAH7003 is connecting.
The Wi-Fi signal strength and the number of wireless clients which are currently connecting
to the WAH7003.
The Internet connection is up.
The current battery level and charging state.
The mode you configured in the WAN > Connection > Connection Operation screen. It
shows how the WAH7003 connects to an available mobile network.
There is no SIM card inserted.
To Next Page
Loading...
