Chapter 9 System
WAH7003 User’s Guide
71
9.9.2 Log Display Screen
Use this screen to see the logged messages for the WAH7003. Click System > Log Display. The
screen displays as shown.
The log wraps around and deletes the old entries after it fills. Select what logs you want to see from
the Display Log Level drop list. When you select a log level, the WAH7003 searches through all
logs of that level or higher. Click Refresh to renew the log screen. Click Clear Log to delete all the
logs.
This screen displays the time the log message was recorded. It also displays the reason the log
message was generated.
Figure 48 System > Log Display
9.10 Reboot Screen
Use this screen to restart the device.
If you applied changes in the Web configurator, these were saved automatically and do not change
when you reboot.
Reboot is different to reset; reset returns the device to its default configuration.
This screen allows remote users can restart the device. To access this screen, click System >
Reboot.
Figure 49 Maintenance > Reboot
Click the OK button to restart the WAH7003. Wait a few minutes until the login screen appears. If
the login screen does not appear, type the IP address of the device in your Web browser.
To Next Page
Loading...
