Chapter 4 WAN
WAH7003 User’s Guide
25
•Use the PLMN 2G/3G Modem screen to display available Public Land Mobile Networks and
select a preferred network for roaming (Section 4.9 on page 30).
4.2 Connection Operation Screen
Use this screen to change your WAH7003’s Internet access settings. Click WAN > Connection >
Connection Operation. The screen appears as shown next.
Figure 10 WAN > Connection > Connection Operation
The following table describes the labels in this screen.
Table 11 WAN > Connection > Connection Operation
LABEL DESCRIPTION
Flight Mode Select to enable or disable flight (airplane) mode on the WAH7003 and click Change to save
your settings.
When the WAH7003 is in flight mode, cellular services and signal transmitting functions
(such as Wi-Fi) are turned off.
Preferred
Cellular
Network
Select how you want the WAH7003 to connect to an available mobile network using the
applied profile settings and click Change to save your settings.
Select Manual Mode to manually establish a connection to the mobile network.
Select Auto Mode to have the WAH7003 automatically connect to the mobile network and
the connection is always up until the WAH7003 is turned off.
Select On Demand to have the WAH7003 connect to the mobile network only when there is
traffic.
Roaming mode Select to enable or disable roaming mode on the WAH7003 and click Change to save your
settings.
3G roaming is to use your mobile device in an area which is not covered by your service
provider. Enable roaming to ensure that your WAH7003 is kept connected to the Internet
when you are traveling outside the geographical coverage area of the network to which you
are registered.
Type This field displays the connection type.
State This field displays the connection status.
Signal This field displays the current signal strength to the mobile network.
The icon is grayed out if the mobile data connection is down.
Profile This field displays the name of the profile used to connect to the mobile network.
To Next Page
Loading...
