Chapter 4 WAN
WAH7003 User’s Guide
27
4.4 2/3G Modem Settings Screen
Use this screen to change your WAH7003’s 2G/3G settings. Click WAN > 2/3G Modem >
Settings. The screen appears as shown next.
Figure 12 WAN > 2/3G Modem > Settings
The following table describes the labels in this screen.
User This field displays the user name in the profile.
Type the user name (of up to 31 printable ASCII characters) given to you by your service
provider.
Password This field displays the password in the profile.
Type the password (of up to 31 printable ASCII characters) associated with the user name
above.
Click an entry’s delete icon to remove the profile.
Click the add icon to create a new entry.
Click the OK icon to save the profile settings.
Click the delete icon to remove all profiles.
Total Num This field displays the total number of profiles configured on the WAH7003.
Apply Click this button to save your changes to the WAH7003.
Table 12 WAN > Connection > User Profile (continued)
LABEL DESCRIPTION
Table 13 WAN > 2/3G Modem > Settings
LABEL DESCRIPTION
Network Type Select the type of the network (3G Only, or 2G Only) to which you want the WAH7003 to
connect and click Change to save your settings.
Otherwise, select Auto to have the WAH7003 connect to an available network using the
default settings on the SIM card. If the currently registered mobile network is not available
or the mobile network’s signal strength is too low, the WAH7003 switches to another
available mobile network.
To Next Page
Loading...
