Chapter 9 System
WAH7003 User’s Guide
65
Do not turn off the WAH7003 while configuration file upload is in
progress.
After the WAH7003 configuration has been restored successfully, the login screen appears. If you
uploaded the default configuration file you may need to change the IP address of your computer to
be in the same subnet as that of the default device IP address (192.168.0.254).
9.3.3 Reset to Default
Click the Reset button to clear all user-entered configuration information and return the WAH7003
to its factory defaults. The WAH7003 automatically restarts.
You can also press the Reset button on the rear panel to reset the factory defaults of your
WAH7003. Refer to Section 1.7 on page 11 for more information on the Reset button.
9.4 Firmware Upgrade Screen
This screen allows you to upload new firmware to your WAH7003. You can download new firmware
releases from your nearest ZyXEL FTP site (or www.zyxel.com) to use to upgrade your device’s
performance.
Only use firmware for your device’s specific model.
To access this screen, click System > Firmware Upgrade. Type in the location of the file you want
to upload in the File name field or click Browse ... or Choose File to find it. Remember that you
must decompress compressed (.ZIP) files before you can upload them. Click Upgrade to begin the
upload process.
The upload process uses HTTP (Hypertext Transfer Protocol) and may take up to two minutes. After
a successful upload, the system will reboot.
Do NOT turn off the WAH7003 while firmware upload is in progress!
Figure 41 System > Firmware Upgrade
To Next Page
Loading...
