Chapter 9 System
WAH7003 User’s Guide
68
The following table describes the labels in this screen.
9.7.2 Time Zone Screen
To change your local time zone and configure daylight saving time, click System > Date and Time
> Time Zone. The screen displays as shown.
Figure 45 System > Date and Time > Time Zone
Table 38 System > Date and Time > Date
LABEL DESCRIPTION
Current System
Time
This field displays the present time and date of your WAH7003.
Mode Select Get from Time Server to have the WAH7003 get the time and date from the
time server you specify. The WAH7003 requests time and date settings from the time
server under the following circumstances.
• When the WAH7003 starts up.
• When you click Apply in this screen.
• 24-hour intervals after starting up.
Select Manual to enter the time and date manually. If you configure a new time and
date, time zone and daylight saving at the same time, the time zone and daylight saving
will affect the new time and date you entered. When you enter the time settings
manually, the WAH7003 uses the new setting once you click Apply.
Time Protocol Select a networking protocol which will be used for clock synchronization with the time
server.
The following fields are available if you set Mode to Manual.
New Time
(hh:mm:ss)
This field displays the last updated time from the time server or the last time configured
manually.
When you set Mode to Manual, enter the new time in this field and then click Apply.
New Date
(mm-dd-yyyy)
This field displays the last updated date from the time server or the last date configured
manually.
When you set Mode to Manual, enter the new date in this field and then click Apply.
The following fields are available if you set Mode to Get from Time Server.
Time Server
Address 1~4
Enter the IP address or URL of your time server. Check with your ISP/network
administrator if you are unsure of this information.
Apply Click Apply to save your changes back to the WAH7003.
To Next Page
Loading...
