Chapter 7 Wi-Fi
WAH7003 User’s Guide
44
7.3 WPS Screen
Use this screen to configure Wi-Fi Protected Setup (WPS) on your WAH7003.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See Section 7.6.5.3 on page 54 for more information about WPS.
Note: To use the WPS feature, make sure you have wireless enabled in the Wi-Fi > Basic
screen.
Note: If you want to use the WPS feature set the security type to WPA or None.
Click Wi-Fi > WPS. The following screen displays. Select On and click Apply to activate the WPS
function. Then you can configure the WPS settings in this screen.
Figure 27 Wi-Fi > WPS
The following table describes the labels in this screen.
Table 27 Wi-Fi > WPS
LABEL DESCRIPTION
Enable Select On to activate WPS on the WAH7003. Otherwise, select Off.
Configure State The default WPS status is configured.
Select Unconfigure to remove all configured wireless and wireless security settings for
WPS connections on the WAH7003.
Configure
Method
•Select PCB to set up a WPS wireless network using Push Button Configuration (PBC).
If you select PCB, click Apply to add another WPS-enabled wireless device (within wireless
range of the WAH7003) to your wireless network. This button may either be a physical
button on the outside of device, or a menu button similar to the Connect button on this
screen.
Note: You must press the other wireless device’s WPS button within two minutes of pressing
this button.
•Select PIN to set up a WPS wireless network by either entering the PIN of the client into
the WAH7003 or entering the PIN of the WAH7003 into the client.
To Next Page
Loading...
