Chapter 9 System
WAH7003 User’s Guide
66
9.5 Power Saving Screen
This screen allows you to enable and configure the power saving settings in the WAH7003. To
access this screen, click System > Power Saving.
Figure 42 System > Power Saving
The following table describes the labels in this screen.
9.6 Password Screen
It is strongly recommended that you change your WAH7003's system password.
This screen allows you to change an account’s password. See Section 2.2 on page 13 for more
information about login accounts.
Table 36 System > Power Saving
LABEL DESCRIPTION
Enable Auto Power
Saving
Select On to activate power saving mode in the WAH7003. Otherwise, select Off.
Enter Standby
Mode (seconds)
Specify the number of seconds the WAH7003 waits before going into standby mode to
save battery power when the USB port is not connected and there is no wireless clients
associating with the WAH7003.
The WAH7003 wakes up from standby mode when the USB port is connected or there is
a wireless client associating with it.
Enter Hibernate
Mode (seconds)
Specify the number of seconds the WAH7003 waits before going into hibernate mode to
save battery power when the USB port is not connected and there is no wireless clients
associating with the WAH7003.
When the WAH7003 is in hibernate mode, you need to press the power button to wake it
up.
Auto Power Off
(seconds)
Specify the number of seconds the WAH7003 waits before it automatically turns off
when the USB port is not connected and there is no wireless clients associating with the
WAH7003.
Apply Click Apply to save your changes back to the WAH7003.
To Next Page
Loading...
