Chapter 5 Network
WAH7003 User’s Guide
33
The following table describes the labels in this screen.
5.3 LAN DNS Name Screen
Use this screen to view or modify the WAH7003’s host name. To access this screen, click Network
> LAN > DNS Name.
Figure 19 Network > LAN > DNS Name
The following table describes the labels in this screen.
5.4 DHCP Server Screen
The WAH7003 has built-in DHCP server capability that assigns IP addresses to systems that support
DHCP client capability. Use this screen to enable the DHCP server. To access this screen, click
Network > DHCP > DHCP Server.
Table 19 Network > LAN > IPv4
LABEL DESCRIPTION
IP Address This shows the default LAN IP address.
Enter the new IP address for the WAH7003’s LAN interface if you want to change it.
Subnet Mask This shows the default subnet mask.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
Apply Click this button to save your changes back to the WAH7003.
Table 20 Network > LAN > DNS Name
LABEL DESCRIPTION
DNS Device Name This shows the default name used to identify the WAH7003 on the network.
Enter a new host name for the WAH7003 if you want to change it.
Apply Click this button to save your changes back to the WAH7003.
To Next Page
Loading...
