ZyXEL Communications WAH7003 - Firewall Configuration; IP Filter Screen Configuration

WAH7003 User’s Guide
59
CHAPTER 8
Firewall
8.1 Overview
This chapter shows you how to configure the IP filtering, MAC filtering and content filtering settings.
8.1.1 What You Can Do in this Chapter
•Use the IP Filter screen to view and configure IP filtering rules (Section 8.2 on page 59).
•Use the MAC Filter screen to view and configure MAC address filtering rules (Section 8.3 on
page 60).
•Use the Content Filter screen to view and configure content filtering rules (Section 8.4 on page
61).
8.2 IP Filter Screen
The WAH7003 firewall is a packet filtering firewall and restricts access based on the source/
destination computer network address of a packet and the type of application. Use this screen to
configure IP filtering rules. To access this screen, click Security > Firewall > IP Filter.
Figure 36 Security > Firewall > IP Filter
The following table describes the labels in this screen.
Table 32 Security > Firewall > IP Filter
LABEL DESCRIPTION
# This field displays the rule index number.
Click an entry to be able to modify the rule’s settings.
Active This field displays whether the rule is active or not.
Click to enable or disable the rule.
Source IP This field displays the source IP addresses to which this rule applies.