Chapter 6 Tutorials
XMG1930 Series User’s Guide
107
1 Connect your computer to the out-of-band management port (So you can access the Switch without
affected by any IP change caused by configurations). Access the Switch through http://192.168.0.1.
Access the Switch through http://192.168.1.1 by default. Log into the Switch by entering the user name
(default: admin) and password (default: 1234).
2 Go to SWITCHING > VLAN > VLAN Setup > Static VLAN. Click Add/Edit.
3 The following screen appears. Enable the switch button to set this VLAN to ACTIVE. Create a VLAN with
ID of 100. Add ports 4, 5 and 6 in the VLAN by selecting Fixed in the Control field as shown.
De-select Tx Tagging because you do not want outgoing traffic to contain this VLAN tag.
Click Apply.
4 Go to SWITCHING > VLAN > VLAN Setup > VLAN Port Setup, and set the PVID of the ports 4, 5 and 6 to
100. This tags untagged incoming frames on ports 4, 5 and 6 with the tag 100. Click Apply.
To Next Page
Loading...
