Chapter 3 Hardware Panels
XMG1930 Series User’s Guide
49
5 Insert the dust plug into the ports on the transceiver and the cables.
Figure 17 Removing the Fiber Optic Cables
Figure 18 Opening the Transceiver’s Latch Example
Figure 19 Transceiver Removal Example
3.1.4 USB Port
Without Access L3 License
With instructions from customer support, this USB Type C connector is for troubleshooting only.
With Access L3 License
When the Access L3 license is activated in your Switch, connect this port to your computer (using an USB
Type C console cable) if you want to configure the Switch using the command line interface (CLI)
through the console port.
3.2 Rear Panel
The following figures show the rear panels of the Switch. The rear panels contain:
Figure 20 Rear Panel: XMG1930-30
Figure 21 Rear Panel: XMG1930-30HP
To Next Page
Loading...
