Chapter 58 VLAN Mapping
XMG1930 Series User’s Guide
409
ports.
• Use the VLAN Mapping Setup screen (Section 58.3 on page 410) to enable and edit the VLAN
mapping rules.
58.2 Enable VLAN Mapping
Click SWITCHING > VLAN Mapping in the navigation panel to display the screen as shown.
Figure 293 SWITCHING > VLAN Mapping > VLAN Mapping
The following table describes the labels in this screen.
Table 218 SWITCHING > VLAN Mapping > VLAN Mapping
LABEL DESCRIPTION
Active Enable the switch button to enable VLAN mapping on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the VLAN mapping feature on this port. Clear this check box to
disable the VLAN mapping feature.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
