ZyXEL Communications XMG1930-30 - Configuring Subnet Based VLAN

Chapter 56 VLAN
XMG1930 Series User’s Guide
391
Figure 274 Subnet Based VLAN Application Example
56.8 Configuring Subnet Based VLAN
Click the SWITCHING > VLAN > Subnet Based VLAN Setup link in the navigation panel to display the
configuration screen as shown.
Figure 275 SWITCHING > VLAN > Subnet Based VLAN Setup
The following table describes the labels in this screen.
Table 205 SWITCHING > VLAN > Subnet Based VLAN Setup
LABEL DESCRIPTION
Active Enable the switch button to activate this subnet based VLANs on the Switch.
DHCP-VLAN
Override
When DHCP snooping is enabled DHCP clients can renew their IP address through the DHCP
VLAN or through another DHCP server on the subnet based VLAN.
Enable the switch button to force the DHCP clients in this IP subnet to obtain their IP
addresses through the DHCP VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This is the index number identifying this subnet based VLAN.
Active This field shows whether the subnet based VLAN is active or not.