Chapter 79 Networked AV Mode
XMG1930 Series User’s Guide
612
79.25 SWITCHING
The following sections introduce the SWITCHING screens.
79.26 Port Mirroring
Port mirroring allows you to copy a traffic flow to a monitor port (the port you copy the traffic to) in order
that you can examine the traffic from the monitor port without interference.
Click SWITCHING > Mirroring in the navigation panel to display the Mirroring screen. Use this screen to
select a monitor port and specify the traffic flow to be copied to the monitor port.
BPDU Ctrl Configure the way to treat BPDUs received on this port. You must activate Bridging Control
Protocol Transparency in the SYSTEM > Switch Setup screen first.
Select Peer to process any BPDU (Bridge Protocol Data Units) received on this port.
Select Tunnel to forward BPDUs received on this port.
Select Discard to drop any BPDU received on this port.
Select Network to process a BPDU with no VLAN tag and forward a tagged BPDU.
Media Type You can insert either an SFP+ transceiver or an SFP+ Direct Attach Copper (DAC) cable into the
10 Gigabit interface of the Switch.
Select the media type (SFP+ or DAC10G) of the SFP+ module that is attached to the 10 Gigabit
interface.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 347 PORT > Port Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
