ZyXEL Communications XMG1930-30 - CHAPTER 1 Getting to Know Your Switch

XMG1930 Series User’s Guide
28
CHAPTER 1
Getting to Know Your Switch
1.1 Introduction
This chapter introduces the main features and applications of the Switch.
The XMG1930 Series consists of the following models:
• XMG1930-30
• XMG1930-30HP
References to PoE model in this User's Guide only apply to XMG1930-30HP.
All models are referred to as the “Switch” in this guide.
The Switch is a smart managed switch supporting Multi-Gigabit ports. The Switch provides SFP+ slots for
uplink. By integrating static route functions, the Switch performs wire-speed layer-3 routing in addition to
layer-2 switching.
The Switch supports NebulaFlex for hybrid mode which can set the Switch to operate in either
standalone or Nebula cloud management mode. When the Switch is in standalone mode, it can be
configured and managed by the Web Configurator. When the Switch is in Nebula cloud management
mode, it can be managed and provisioned by the Zyxel Nebula Control Center (NCC).
The following table describes the hardware features of the Switch by model.
1.1.1 License Option
At the time of writing, the Switch license unlocks advanced features with additional access Layer-3
functions as shown in the following table. See Section 78.17 on page 577 for more information on how to
activate the license and display the license status.
Note: The license services requires ZyNOS 4.80 firmware on your Switch.
Table 1 XMG1930 Series Model List
PORT DESCRIPTION XMG1930-30 XMG1930-30HP
100M, 1G, and 2.5G RJ-45 Ethernet Ports 24
20
100M, 1G, and 2.5G RJ-45 Ethernet Ports with IEEE 802.3at No
1G, 2.5G, 5G, and 10G RJ-45 Ethernet Ports 4
4
1G, 2.5G, 5G, and 10G RJ-45 Ethernet Ports with IEEE 802.3bt (60 W) No
100M, 1G, and 2.5G PoE Ports with IEEE 802.3bt (60 W) No 4
1G, 10G SFP+ Interface 2 2
Total System Ports 30 30