Chapter 53 Spanning Tree Protocol
XMG1930 Series User’s Guide
351
53.2 Spanning Tree Protocol Status
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status
to see the screen as shown.
Figure 241 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status (Without Access L3
License)
Figure 242 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status (With Access L3
License)
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the Switch. This
screen is described in detail in the section (Section 53.4 on page 354, Section 53.6 on page 359, and
Section 53.8 on page 364) that follows the configuration section for each STP mode. Use the SWITCHING
> Spanning Tree Protocol > Spanning Tree Setup screen to activate one of the STP standards on the
Switch.
To Next Page
Loading...
