Chapter 45 Multicast
XMG1930 Series User’s Guide
316
Figure 214 SWITCHING > Multicast > MVR > Group Setup
The following table describes the labels in this screen.
45.13.1 Add/Edit MVR Group
Use this screen to configure MVR IP multicast group addresses. To access this screen, click the Add/Edit
button or select an entry from the list and click the Add/Edit button.
Figure 215 SWITCHING > Multicast > MVR > Group Setup > Add/Edit
Table 156 SWITCHING > Multicast > MVR > Group Setup
LABEL DESCRIPTION
MVLAN This field displays the multicast VLAN ID.
Group Name This field displays the descriptive name for this setting.
Start Address This field displays the starting IP address of the multicast group.
End Address This field displays the ending IP address of the multicast group.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new multicast group or edit a selected one.
Delete Select the group entries that you want to remove, then click Delete to delete the selected
multicast groups.
If you delete a multicast VLAN, all multicast groups in this VLAN will also be removed.
To Next Page
Loading...
